Industry · abrasion · chemical · high bond
Industrial & Specialty
General manufacturing, converting and facility work: bundling, splicing, protection, floor marking and anything that has to hold under vibration and chemical exposure.
Typical tasks
- Web splicing on paper, film and foil lines
- Surface protection during fabrication, storage and shipping
- Floor marking, walkway anti-slip and safety identification
- Equipment bundling, temporary fixturing and general repair
Before we quote, we need
- Line speed and web tension
- Substrate and surface finish
- Chemical or solvent exposure
- Width, length and annual volume
Selection warnings
Warnings here are the failure modes we see most often in this industry, not disclaimers.
Splice strength must be compared against the running web strength, not against a generic peel number.
Protection film adhesion that is right for one surface will over-bond or fall off on another; test on the real surface.
Anti-slip rating depends on the substrate and contamination level, not only on the grit.
Products that cover this industry
Localized fixing and seaming of MLI and reflective insulation in cryogenic and vacuum-jacketed systems.
Mechanical protection and reinforcement of insulation packages, where tear resistance matters more than reflectivity.
Solder masking, wave-solder protection, coil and transformer insulation, and 3D-print bed surfaces.
Powder-coating masking, PCB plating and conformal-coating protection, and heat-transfer printing.
Spray painting, lacquering, wall and woodwork masking, with controlled edge bleed and easy removal.
Release surfaces, heat-sealer and packaging-machine covers, chute liners and non-stick protection.
Tear-resistant strapping, splicing and general reinforcement where a hand-tearable backing is too weak.
Structural mounting of panels, nameplates, trims and decorative parts, absorbing thermal expansion and vibration.